Remote Control Setup; Set Up The Remote Control; Scan For Device Codes - Dish Network Platinum PVR Remote Control User Manual

text_dishpvr.fm Page 4 Thursday, July 12, 2001 10:02 AM
R C
EMOTE ONTROL
S U R
ET P THE EMOTE
On the next few pages we tell you how to set up the remote to control
a TV, a VCR, or other devices.
When you get the remote it's already set up to control the
receiver. But, you must set up the remote to control the
TV before you can use the Mute and Volume buttons.
To do this, you can either Scan for Device Codes here
or Try the Device Codes on page 5.
S D C
CAN FOR EVICE
1. Use the device's buttons or its remote control to turn it on.
2. Press and hold the mode button for the device, for about three
seconds. When all the other mode buttons light up, let go of the
button. For example, hold the TV button for a TV.
3. Only for the Aux mode, use the number buttons
to enter 0 for a second TV, 1 for a second VCR,
or 2 for a tuner or amplifier.
For any other mode, skip to step 5.
4. Only for the Aux mode, press the Star (*) button.
For any other mode, skip to step 5.
5. Press the blank Power button.
6. Press the up or down arrow button to set the
remote to the next code. The up arrow button
scans ahead and the down arrow button scans back.
Press the button again to go on with the scan.
7. If the remote reaches the correct code, the device
turns off. When this happens, press the Pound (#)
button to store the code in the remote. If the code
works, the mode button flashes three times.
(please go on to the next page)
4
S
ETUP
C
ONTROL
ODES
108933