Dish Network VIP222 Remote Control Setup page 10

222.book Page 66 Tuesday, July 25, 2006 1:30 PM
Chapter 9
Controlling Other Components
For AUX mode: The first group of
flashes tells you what the AUX mode
controls. A quick flash (zero) before the
three-digit code is for a TV; one regular
flash is for a VCR; and two flashes is
for a tuner, or amplifier.
For a satellite receiver programmed in
AUX mode: The AUX mode button will
flash the same number of times as the
address number.
For Limited Mode: If you have
programmed a TV or VCR in Limited
Mode, the mode button flashes once at
the end of the flash sequence.
Controlling a Tuner/Amplifier
Use the following remote control buttons to control a tuner or amplifier. When the remote
control is set up as described on pages 61 and 67, press the AUX mode button to set the
remote to AUX mode. The AUX mode button will stay lit for two seconds to show you've
set the remote to AUX mode. Make sure to keep the remote in AUX mode to use the
following buttons.
66
Instructions Additional Information
For example, if the TV code is 570, the AUX
mode button flashes once quickly (indicating 0
for TV), pauses, flashes five times, pauses,
flashes seven times, pauses, and flashes once
quickly.
For example, if the receiver address is 3, the
AUX mode button flashes three times.
For example, if the TV code is 570, the AUX
mode button flashes once quickly (indicating 0
for TV), pauses, flashes five times, pauses,
flashes seven times, pauses, flashes once
quickly, and then flashes once (indicting
Limited Mode).