Setting Up Using Device Codes Scan - Dish Network DuoDVR ViP 722_TOC User Manual

Setting Up Using Device Codes Scan

If the code for your device is not listed in the tables starting on page 132 or if you could not find a
code that worked for your device, use this procedure to scan the remote control's memory for the
device code. In the instructions below, the column on the left contains the instructions and the
column on the right provides additional information.
1
VCR
Turn
device on
Instructions
1. Turn the device on.
2. Press and hold the mode button until all the
other mode buttons light up, and then
release the button. The mode button
flashes.
3. For AUX mode only. Press 0 for TV, 1 for
VCR, or 2 for a tuner, or amplifier. Then
press the STAR (*) button.
4. Press POWER.
Instructions
5. Press the UP or DOWN ARROW
repeatedly until the device turns off.
6. Press POUND (#).
7. Turn the device back on and try some other
buttons to make sure they work.
8. If necessary, repeat this procedure until
you've tried all the codes.
4
2-3
VCR
Press
Press & hold
POWER
Mode button
Press UP or
until all Mode
DOWN ARROW
buttons light up
until device
Additional Information
Use the device's front panel buttons or its remote control.
For example, hold the TV mode button until all of the other
mode buttons light. When you let go, TV will flash.
This step is for programming the type of device that will be
programmed in AUX mode. If you're not programming in
AUX mode, skip to step 4.
This puts your remote in the scan mode.
Additional Information
As you press the
tries each code in the memory to see if it can turn off your
device. When the device turns off, you have found a code
that might work.
Note: The mode button for the device will flash rapidly eight
times when you've scanned all the codes for that device.
The mode button flashes three times if you have entered
the code correctly, and stores the code you found.
Sometimes
using Limited Mode, try VOLUME or MUTE.
You may need to repeat the scan to find the best code for
your device.
Remote Controls
Controlling Other Components
5
6
Press
Turn device back on
POUND
and test to make
sure code works
turns off
UP DOWN ARROW
or
POWER
works when other buttons don't. If
7-8
VCR
, the remote
77