Dish Network DuoDVR ViP 722_TOC User Manual page 28

Chapter 10
The Recover Button
your satellite TV video. If RECOVER is programmed to a specific channel, RECOVER will tune the
TV to the specific channel first (for example, channel 60).
Programming the Recover Button for Remote Control 2
When your Remote Control 2 is shipped from the factory, RECOVER is set up to restore satellite
TV viewing by tuning your TV (or VCR) to channel 3, 4, and other inputs. To use RECOVER with
your remote TV (or VCR), you need to program RECOVER with the specific three-digit number
channel that you use to watch TV2 programming. (For two-digit number channels, use zero first.
For example, enter channel 60 as 060.) The following instructions describe how to program
RECOVER to tune your remote TV (or VCR) back to a selected channel.
POWER
TV VCR
SAT AUX
TV/VIDEO TV PAGE
MENU
P VOLUME
MUTE GUIDE
E SELECT O
RECALL CANCEL
INFO VIEW TV
DVR
SKIP SKIP
BACK FWD
BACK FWD
PAUSE
STOP PLAY
R
RECORD
PIP
P abc def O
ghi jkl mno
pqrs tuv wxyz
/format search
1
Program Remote 2 to
control your remote
Using the Recover Button
The following setup is required to use RECOVER:
• The remote control must be set up to control the TV and, if installed, the VCR.
• If a VCR is installed, it must be connected as shown on page 109.
• On a remote TV, RECOVER must be programmed to tune your remote TV to the specific
channel to receive TV2 programming (for example, channel 60), using the instructions on
page 82.
1
Make sure
your TV is
on
Note: Press any remote control button other than RECOVER to end this procedure.
Note: If RECOVER is not programmed to a specific channel, RECOVER will first try to tune your
TV to channel 3, then channel 4, and then other video inputs with each press of RECOVER. You
may need to press RECOVER up to 30 times to recover your satellite TV video. If RECOVER is
programmed to a specific channel (see page 82), RECOVER will tune the TV to the specific
channel (for example, channel 60).
82
2
1
TV
Press and hold the
TV Mode button until all
Mode buttons light up
(button will flash)
TV
3
2
Press RECOVER
again and wait for the
Press
TV or VCR Mode
and hold
buttons to flash once
RECOVER
then all four Mode
until all buttons to flash once
Mode buttons
light up
3
4
Press
STAR
Enter the
digits of your
channel number
4
System Info Mon, October 18
2
0
a c
Status: Good b
0
DISH Player-DVR 522 R00 0000 0000-01
d e f
Software: L236 S00 0000 0000-01
Satellite: 110 119 148
g
Signal:
h Device: DP34, Feed(1), Feed(2), Feed(3)
Remote Addrs. 5 Remote Addrs. 5
i 1 j 2
3 3
TV Out TV Out
UHF UHF
Details Done Next
Copyright 2005, EchoStar Technologies Corp. All Rights Reserved.
Don't see the System
When the System
Information screen
displays, you have
until the System Information
recovered your satellite
programming
(press SELECT to exit)
SELECT
5
Press POUND
(TV Mode button
will flash 3 times)
5
Information Screen?
Repeat steps 2 & 3
screen appears