Rotary Volume Knob Operation Mode Select - Kenwood KDC-7027 Instruction Manual

2nd section
[2] button
Adjustment Item Display
Front/Rear High Pass Filter "HPF"
[3] button
Adjustment Item Display
Subwoofer Low Pass Filter "LPF SW"
[4] button
Adjustment Item Display
Loudness "LOUD"
[5] button
Adjustment Item Display
Balance "Balance"
Fader "Fader"
• When the Dual Zone System is ON, the setting for the
High Pass Filter is nullified.
3rd section
[2] button
Adjustment Item Display
Volume offset "V-Offset"
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
Rotary Volume knob operation
mode select
The rotary volume knob can be used for volume
Range
adjustment and various function setups.
THRU/100/125/170 Hz
Available setup functions
Range
50/80/120/THRU Hz
Range
ON/OFF
Range
L 15 — R 15
R 15 — F 15
To use the rotary volume knob:
1
2
Range
3
–8 — 0
4
The rotary volume knob can be used for the
following setup:
• Menu system : Item selection
• Audio Control : Adjustment of setup value
• Display control : Display switching
• Disc Naming (DNPS) : Character selection
• Folder select : Folder search
• You can select the Rotary Volume Operation mode
" "
only when the indicator is displayed above the [1]
button during any function setup.
• When the " " indicator is OFF, you cannot use the
rotary volume control for function setup and sound
level adjustment.
Turn the rotary volume operation ON
See the 'Rotary volume operation select' (37
page) and select "Rotary ON".
Selecting the Rotary Volume Operation
mode
Press the [1] button.
When it's ON, the " " indicator blinks.
Setting the function
Rotate the Rotary Volume knob.
Terminates the function setup using the
rotary volume knob
Press the [1] button.
13
|
English