Table of Contents
Advertisement
KRC-594/V/Y/YV
How to remove the Volume Knob
1. Remove the rear cover of panel unit.
2. Juck up as remove the switch unit (x16-) and Volume Knob
as shown.
(CAUTION)
Volume Knob cannot pull of front side that looked at tab
point in the rotary encoder.
2
DISASSEMBLY FOR REPAIR
KNOB(VOL)
How to install the Volume Knob
1. Remove the peeling paper of LIGHTING BOARD BOSS
side.
2. CAP and LIGHTING BOARD are install positioning as
shown.
LIGHTING BOARD
CAP
3. Remove the peeling paper.(Use Tweezers)
4. CAP and Volume Knob are install positioning as shown.
Rib: short
5. Install a Volume Knob in rotary encoder positioning as
shown.
Be careful of direction.
Rib: tall
CAP
KNOB(VOL)
Dented part
Mount the Volume Knob into
the broad Y shaped cutting in
the direction of the picture.
BROAD SIDE
OTHER SIDE
Advertisement
Table of Contents
