Remote Controlled Chirp Muting; Panic Mode - Clifford MATRIX 1 Owner's Manual

To disarm the security system, turn
the ignition to the "on" position.
Press the Valet switch the preset
number of times (1-5 times) within 15 seconds. After 1.5
seconds the system should disarm. If it does not, you may have
waited too long; turn the ignition off and on and try again.
important! The unit can be programmed to respond to 1-5
pulses of the Valet switch for the disarm function. Be sure
to check with the installer for the desired programming.
Location of Valet Switch_________________________________
➜

remote controlled chirp muting

To temporarily turn off the arm or disarm chirps, use Remote
Controlled Chirp Muting. Simply press
mitter briefly before arming or disarming, and the confirmation
chirp(s) will be eliminated for that one operation only. If you
want the arm/disarm chirps turned off permanently, your dealer
can do this for you.
note: The Warning Zone response to lighter impacts is
bypassed if the system is armed using Remote Controlled
Chirp Muting. This ensures that no chirps will be emit-
ted by the siren in an area you want chirp-free. The sys-
tem is still fully capable of triggering. Only the Warning
Zone response is bypassed.
➜

panic mode

If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your transmitter! Just
10
DRW-35
on the trans-
© 2001 directed electronics, inc.