Panasonic AWRP50N - REMOTE CAMERA CONTROLLER Operating Instructions Manual page 28

Connections
3
Turn the F2 dial, select "Yes", and then
press the F2 dial.
This starts the "Auto IP setting" process.
When "Auto IP setting" has been initiated, the
progress is shown by the number of displayed
dots which are reduced one by one.
A U T O S ET UP
When all the operations have been completed
successfully, "COMPLETE!" is displayed.
A U T O S ET UP
The remote cameras and the switcher are
automatically rebooted, and they restart with the
new IP addresses which were set.
The remote cameras can now be operated from
the unit.
The function for linking the switcher with the unit
becomes available for use at this point.
 Memo 
If the IP addresses were not set successfully,
"SET UP ERR!" is displayed.
A U T O S E TU P
S E T UP ER R!
The cause of the problem is likely a network
malfunction.
Check the connection status of the hub and LAN
cables, and then retry the "Auto IP setting" operation.
C OM PL ET E!
28