Testing Your System; To Perform The Transponder Test - DirecTV HAH-SA Owner's Manual

Testing your system

To perform the Transponder
When you have aligned your dish antenna to the azimuth and elevation angles
shown on the
Install
by a scale at the bottom of the pane and with an audible indication. The
frequency and tempo of the tone increase with signal strength.
Use this procedure to test the signal strength from the satellite transponder:
test:
1. Select the
System Setup
2. Highlight the
3. Highlight the Test menu button as shown in the figure below.
4. Press
SELECT
5. Press
SELECT
Note: Xponder and Source selections displayed may vary from those shown.
pane, highlight the
Signal
tab from the
tab to display the
Signal
to display the Transponder Test menu (see figure below).
to begin the test on the highlighted selection.
tab. Signal quality is indicated
MAIN MENU
menu pane.
SIGNAL STRENGTH
)
)
)
Getting Started
5