KitchenAid KDSS907SSS Installation Instructions Manual page 22

4. Gas orifice spuds are stamped with a number on the side.
Replace the LP gas orifice spud with the correct Natural gas
orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart for Standard Surface Burners
Burner Location Burner Rating
Right front 6,000 Btu/h
Left front 14,000 Btu/h
Right rear 12,500 Btu/h
Left rear 6,000 Btu/h
5. Place LP gas orifice spuds in plastic parts bag for future use
and keep with literature package.
6. Replace burner cap.
7. Repeat steps 1-6 for the remaining burners, except for the
TripleTier ® Flame burner (on some models). See "To Convert
®
TripleTier Flame Burners" section.
To Convert TripleTier Flame Burner (on some models)
®
1. Remove burner cap.
2. Remove the burner head using a size T20 TORX
3. Remove the plate on the external gas orifice spud.
A. Burner caps
B. Burner heads
C. External gas orifice spud access plate
D. Internal gas orifice spud
22
A
Size
1.10 mm
1.70 mm
1.61 mm
1.10 mm
® screwdriver.
A
B
C
D
IMPORTANT: The TripleTier
spuds. Do not forget to change the external gas orifice spud
located under the plate.
B
C
A. Plate
B. External gas orfice spud
C. Internal gas orifice spud
4. Apply masking tape to the end of a
hold the internal gas orifice spud in the nut driver while
changing it. Press nut driver down onto the internal gas
orifice spud and remove by turning it counterclockwise and
lifting out. Set internal gas orifice spud aside.
5. Use a 7 mm combination wrench to remove the external
orifice spud. Turn counterclockwise remove, set external gas
orifice spud aside.
6. Replace the LP gas orifice spud with the correct Natural gas
orifice spud. Refer to the following chart for correct Natural
gas orifice spud placement.
Natural Gas Orifice Spud Chart for TripleTier
Burner Location Burner Rating
Left front (external 12,200 Btu/h
®
TripleTier burner)
Left front (internal
TripleTier ® burner)
7. Replace burner plate, head and cap.
8. Place LP gas orifice spuds in plastic parts bag for future use
and keep with literature package.
9. Reinstall the warming drawer. See the "Replace Oven Racks
& Warming Drawer" section for instructions.
10. Complete installation. See "Make Gas Connection" and
"Electronic Ignition System" sections.
Checking for proper cooktop burner flames is very important.
Natural gas flames do not have yellow tips.
IMPORTANT: You may have to adjust "LO" setting for each
cooktop burner.
® Flame burner has 2 gas orifice
A
mm nut driver to help
® Flame Burners
Size
1.70 mm
2,800 Btu/h 0.70 mm