KitchenAid KDSS907SSS Installation Instructions Manual page 20

9. Reinstall the cap onto the regulator.
E D
A. Access cap
B. Gasket
C. Gas pressure regulator
To Convert Standard Surface Burners
1. Remove burner cap.
2. Using a T20 TORX ® screwdriver, remove the burner base.
3. Apply masking tape to the end of a
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A
B
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
4. Gas orifice spuds are stamped with a number, marked with
1 color dot, and have a groove in the hex area. Replace the
Natural gas orifice spud with the correct LP gas orifice spud.
A. Groove
Refer to the following chart for correct LP gas orifice spud
placement.
LP Gas Orifice Spud Chart for Standard Surface Burners
Burner Location Burner Rating
Right front 5,000 Btu/h
Left front 13,000 Btu/h
Right rear 10,000 Btu/h
Left rear 5,000 Btu/h
20
A
B
C
D. Spring retainer
LP position
E. Spring retainer
NAT position
mm nut driver to help
C
D
A
Color Size
Red 0.70 mm
Green 1.10 mm
Blue 0.95 mm
Red 0.70 mm
5. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with literature package.
6. Replace burner cap.
7. Repeat steps 1-6 for the remaining burners, except for the
TripleTier ® Flame burner (on some models). See "To Convert
®
TripleTier Flame Burners" section.
To Convert TripleTier Flame Burners (on some models)
®
1. Remove burner cap.
2. Remove the burner head using a size T20 TORX
3. Remove the plate on the external gas orifice spud.
A. Burner caps
B. Burner heads
C. External gas orifice spud access plate
D. Internal gas orifice spud
IMPORTANT: The TripleTier
spuds. Do not forget to change the external gas orifice spud
located under the plate.
A
B
C
A. Plate
B. External gas orifice spud
C. Internal gas orifice spud
4. Apply masking tape to the end of a
hold the internal gas orifice spud in the nut driver while
changing it. Press nut driver down onto the internal gas
orifice spud and remove by turning it counterclockwise and
lifting out. Set internal gas orifice spud aside.
5. Use a 7 mm combination wrench to remove the external gas
orifice spud. Turn counterclockwise to remove. Set external
gas orifice spud aside.
6. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. Refer to the following chart for correct LP gas
orifice spud placement.
® screwdriver.
A
B
C
D
® Flame burner has 2 gas orifice
mm nut driver to help