Lesson 2: Loading Files Into The Sequencer - ScanSoft Kai’s Power SHOW User Manual

The selected thumbnails are
automatically sorted by width.
This is what your desktop looks like after the
thumbnails are sorted by width.
Now that your photos are sorted, you can
start adding them to the Sequencer. Once
they're in the Sequencer, they're part of
your show.
Lesson 2: Loading files into the
Sequencer
The Sequencer, located at the bottom of
the SORT and EDIT Rooms, offers a
visual representation of the content and
order of your show. You can use the
Sequencer to arrange content and to
preview your show as you work on it.
When moving between the SORT and
EDIT Rooms, notice that Sequencer
content and order remain the same.
22 Kai's Power SHOW
In this lesson you'll add the sorted photos
to the Sequencer using the Sequence
Floatoid and the Select cursor.
To add thumbnails to the Sequencer
using the Sequence Floatoid:
1. Drag a bounding box around a few of
the thumbnails on the desktop. The
Sequence Floatoid appears.
Select thumbnails and the Sequence Floatoid
appears.
2. Click the Sequence Floatoid to load all
of the selected thumbnails into the
Sequencer.
Remember, the Floatoid loads all the
selected thumbnails into the
Sequencer. If you don't want to load a
specific thumbnail, deselect it first.
The Sequence Floatoid loads content in
order, from left to right and from top to
bottom. You can also add content to the
Sequencer using the Sort control's
Sequence cursor.
To add photos to the Sequencer using
the Sequence cursor:
1. Move your cursor over the Select
label. The Select control appears.
The Select control in its minimized state.
2. Click the Select control. The Select
buttons appear.