Directed Electronics Ready Remote Owner's Installation Manual page 51

Directed electronics ready remote owner's installation guide
Table of Contents

Advertisement

step 11
Testing the system
Once steps 1-10 have been completed, the operation of the
system can be tested.
note: If power has been removed or the fuses removed,
the remote(s) will have to again be learned to the system.
Ensure that the two 30-amp fuses are in the relay harness RED
wire fuse holders. Make sure that the vehicle is in park with the
emergency brake on and the hood closed. Press
remote to initiate the remote start function. The parking lights
should flash to confirm the remote start command has been
received, The accessories and ignition should turn on followed
by the starter cranking and the vehicle engine running (this may
take a moment to initiate). Pressing
remote will shut the engine off.
This completes the testing, if all functions do not work correctly
check your wiring against the manual and verify all connections.
If you still experience problems contact Directed Technical
Support at 1 1 - - 8 8 0 0 0 0 - - 4 4 7 7 7 7 - - 1 1 3 3 8 8 2 2 .
© 2006 Directed Electronics
once on the
once again on the
47

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ready Remote and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Ready remote 24923

Table of Contents

Save PDF