Directed Electronics Ready Remote Owner's Installation Manual page 49

To determine what bypass module your vehicle requires, use the
www.designtech-intl.com web-site in the Interface Module Look-
Up section.
➜
step 10
Learning the remote
The system comes with one programmed transmitter. The
receiver can store up to 4 different transmitter codes in memory.
Additional transmitters (part no. 26131) can be ordered by
contacting your local dealer at 1-800-274-0200. Use the
following to add a transmitter to the system.
The following is the basic sequence of steps to remember whenever
programming this unit:
1. F F u u s s e e s s . . Be sure to place the two 30-amp fuses into the relay
harness RED wire fuse holders
© 2006 Directed Electronics
warning! In the following procedure do
not activate the remote start feature with
the remote. This feature will be tested in
the next step.
2. K K e e y y . . Turn the ignition to the ON position.
The parking lights will immediately turn on to
indicate transmitter learn mode. After 5-
seconds the parking lights will turn off and
then turn back on to indicate ready to learn
mode.
45