Directed Electronics Ready Remote Owner's Installation Manual page 23

Directed electronics ready remote owner's installation guide
Table of Contents

Advertisement

wire. With the key in the off position the LED tester should be
extinguished in all key positions except the crank position. In
the crank position your LED tester should illuminate Red, and
will extinguish when the starter disengages.
n n o o t t e e : : Always check the Web site information on your
vehicle for warnings regarding the starter wire and check
engine lights. Some vehicles will trip a check engine light
if the starter wire is cut.
Once you locate the starter wire, cut the wire in half (c c h h e e c c k k t t h h e e
w w e e b b i i n n f f o o r r m m a a t t i i o o n n b b e e f f o o r r e e c c u u t t t t i i n n g g ) and try to start the vehicle. If
the vehicle does not start, the correct wire has been identified.
Reconnect both ends the starter wire while soldering the thick
VIOLET (1) wire of the heavy gauge wires to it and wrap the
connection with electrical tape.
Many Nissan vehicles have two starter wires. A relay (not provided)
is required to hook up the additional starter wire. Refer to the
diagram below.
© 2006 Directed Electronics
19

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ready Remote and is the answer not in the manual?

This manual is also suitable for:

Ready remote 24923

Table of Contents

Save PDF