Advertisement
2. Was the Tach Learn successful? The LED must light solid and bright to indicate a successful learn.
3. Make sure that there is a tach signal at the purple/white tach input wire of the remote start. If there is not
a tach signal, recheck the connection to the vehicle's tach wire and make sure the wire is not broken or
shorted to ground leading to the remote start.
■ T T h h e e v v e e h h i i c c l l e e w w i i l l l l s s t t a a r r t t , , b b u u t t w w i i l l l l o o n n l l y y r r u u n n f f o o r r 1 1 0 0 s s e e c c o o n n d d s s . .
1. Is the remote start programmed for voltage sense? Try programming the unit for low voltage reference. If this
does not work, a tach wire should be used.
2. Check diagnostics.
■ T T h h e e c c l l i i m m a a t t e e c c o o n n t t r r o o l l s s y y s s t t e e m m d d o o e e s s n n o o t t w w o o r r k k w w h h i i l l e e t t h h e e u u n n i i t t i i s s o o p p e e r r a a t t i i n n g g t t h h e e v v e e h h i i c c l l e e . .
Either the wrong accessory wire is being energized or more than one ignition or accessory wire must be ener-
gized in order to operate the climate control system.
5 5 4 4
Advertisement
Need help?
Do you have a question about the ProSecurity SR6000 and is the answer not in the manual?