Directed Electronics ProSecurity SR6000 Installation Manual page 49

t t i i m m e e r r m m o o d d e e
By pressing the remote
run for the set duration. The remote start can be shut off by the transmitter by pressing the remote start button
and remain in timer mode, but if any other shut down zones or the ignition becomes active the timer mode
will cancel.
1. Press Timer mode buttons.
2. The vehicle will confirm with 4 parking light flashes.
3. A 1-second delay will start.
4. The system will start the car and will run for the specified duration, unless shut down by the remote start
button . If shut down with the remote start button
5. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires. To
exit timer mode, turn the ignition switch on any time the engine is not running. The parking lights will flash
4 times, indicating timer mode has been exited.
6. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires.
t t a a b b l l e e o o f f z z o o n n e e s s
When using the Diagnostic functions, use the Table of Zones to see which input has triggered the system. It is
also helpful in deciding which input to use when connecting optional sensors and switches.
Z Z O O N N E E N N O O . . T T R R I I G G G G E E R R T T Y Y P P E E
1 Multiplexed Input
2 Multiplexed Shock Sensor Input Mux BLUE wire.
3 Door Trigger
4 Multiplexed Shock Sensor
5 Ignition
6 Hood Brake Trigger
N N O O T T E E : The Warn Away® response does not report on the LED.
and buttons the parking lights will flash 4 times and then start the vehicle and
I I N N P P U U T T D D E E S S C C R R I I P P T T I I O O N N
BLUE (H1/6)
GREEN (H1/5) and VIOLET (H1/7).
Mux GREEN wire
Yellow ribbon harness wire
GRAY on the 6-pin shutdown harness.
the system will remain in timer mode.
4 4 9 9