Directed Electronics ProSecurity SR6000 Installation Manual page 50

s s h h u u t t d d o o w w n n d d i i a a g g n n o o s s t t i i c c s s
t t o o p p e e r r f f o o r r m m s s h h u u t t d d o o w w n n d d i i a a g g n n o o s s t t i i c c s s
1. With the ignition OFF, press and H H O O L L D D the Valet/Program button.
2. Turn the ignition ON and then back OFF while H H O O L L D D I I N N G G the Valet/Program button.
3. Release the Valet/Program button.
4. Press and release the Valet/Program button. The LED will report the last shutdown for one minute or until
the ignition is turned on.
L L E E D D F F L L A A S S H H E E S S
One
Two
Three
Four
Six
Seven
Eight
l l o o n n g g t t e e r r m m e e v v e e n n t t h h i i s s t t o o r r y y
The system stores the last two full triggers in memory. These are not erasable. Each time the unit sees a full
trigger, the older of the two triggers in memory will be replaced by the new trigger. To access long term event
history:
1.
2.
5 5 0 0
S S H H U U T T D D O O W W N N M M O O D D E E
Timed out
Over-rev shutdown
Low or no RPM
Transmitter shutdown (or optional push-button)
(-) Shutdown (H3/3 GRAY) or (+) Shutdown (H3/4 BROWN)
(-) Neutral safety shutdown (H3/6 BLACK/WHITE)
Wait-to-start timed out
With the ignition off, press and H H O O L L D D the Valet®/Program switch.
Turn on the ignition.