Top Panel Controls; Top Panel Features - Directed Audio 600/4 Owner's Manual

TOP PANEL CONTROLS

1. I I n n p p u u t t G G a a i i n n A A d d j j u u s s t t m m e e n n t t - Controls
amplifier sensitivity and is used to
match the input level of the ampli-
fier to the output level of the signal
source.
2. C C r r o o s s s s o o v v e e r r S S e e l l e e c c t t i i o o n n S S w w i i t t c c h h -
Controls the type of filter for the on-
board active crossovers. FLAT does
not attenuate any frequencies and
is for full-range speaker systems.
HPF attenuates low frequencies and
is used for mid-range speakers and
FIGURE 3—AMPLIFIER CONTROLS 600/4 TOP
2
1

TOP PANEL FEATURES

Control Panel Cover
The gain and filter controls are located
under a control panel cover on top of
the amplifier. The control panel cover
must be removed to gain access to the
gain and filter controls.
10
tweeters. LPF attenuates high
frequencies and is typically used for
subwoofers.
3. C C r r o o s s s s o o v v e e r r F F r r e e q q u u e e n n c c y y A A d d j j u u s s t t m m e e n n t t -
Adjusts the crossover point for the
on board active crossovers.
4. B B a a s s s s E E Q Q S S w w i i t t c c h h - Adds an additional
8 db of boost to the speaker output
when on.
3
4
Remove/Install
Four Allen-head screws hold the control
panel cover to the amplifier top panel,
one at each corner. They can be
removed with the wrench supplied in
the hardware pack.
© 2003 Directed Electronics, Inc