Cisco SMART BUSINESS COMMUNICATIONS SYSTEM - FEATURE REFERENCE GUIDE 12-2010 Feature Reference page 4

Dial Plan
PSTN Trunks
Voice System Features
© 2010 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Inbound call handling X
Outbound call handling X
Public Switched Telephone X
Network (PSTN) number
mapping (DID)
Call forward busy X
Call forward no answer X
Inbound caller ID support X
Outbound caller ID support X
Caller ID blocking X
Call blocking X
Customizable dial plan X
Trunk failover X
Multiple access codes X
Digit collection timeout X
Dial plan test diagnostic X
Central office (CO) trunk X
(FXO)
Analog DID X
BRI X
T1 (PRI) including fractional X
E1 (PRI) including fractional X
T1 (CAS) including fractional X
E1 (CAS) including fractional X
Analog station ports X
(integrated FXS)
ISDN BRI/PRI parameter X
customization
International call progress X
tones
SIP trunks X
Call pickup X
Call park X
Call hold X
Hunt groups X
X Call handling for FXO, Basic Rate Interface (BRI)/T1/E1 incoming call
handling mechanism
X Ability to specify multiple emergency numbers, customized call
blocking capability
X Ability to perform 1-to-1 and 1-to-many DID to internal extension
mapping.
X
X
X Supported on FXO, BRI, Primary Rate Interface (PRI), Session
Initiation Protocol (SIP)
X Supported on BRI, PRI, and SIP. If DID range is noncontiguous,
outbound caller ID is the auto attendant (AA) number.
Supported for configuring caller ID per PSTN trunk and overriding
trunk-level caller ID for individual extensions.
X
X Added ability to customize up to 5 call block numbers or ranges
X
X Support for SIP trunk to PSTN or PSTN to SIP trunk failover
X Support for multiple access codes for any string of digits in the dial
plan
X
X
X Call handling per FXO port can be customized to redirect to
AA/operator/hunt group/shared line; Cisco Configuration Assistant
2.2(5) adds support for overlay on CO trunk line. Cisco Configuration
Assistant 3.0 adds support for detailed FXO trunk settings.
X Supported only on the expansion voice interface card (VIC) slot
X
X
X
X Ear and mouth (E&M) (Wink Start and Immediate Start signaling types
supported). For Foreign Exchange Station (FXS)/FXO, loop start and
ground start signaling types supported.
X E&M (Wink Start and Immediate Start signaling types supported). For
FXS/FXO, loop start and ground start signaling types supported.
X
X Configurable bearer-cap and static TEI settings
X Configurable call progress tone for international locales
X Support for AT&T, Cbeyond, Nuvox, Paetec, XO, Broadview and
British Telecom, FiberNet, and generic SIP provider. Cisco
Configuration Assistant 3.0 adds support for Cablevision, Qwest, and
Portugal Telecom.
X
X Cisco Configuration Assistant 3.0 adds support for call park extension
timeout and recall settings.
X Cisco Configuration Assistant 3.0 adds support for call hold audible
alert settings.
X Includes sequential, peer, simultaneous (call blast), and longest idle
hunt group types
Feature Description Guide
Page 4 of 27