Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - MANAGING VULNERABILITY ASSESSMENT V1 Manual page 13

Step 6
Step 7
Step 8
Editing an ip360
Scanner
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Deleting an ip360
Scanner
Step 1
Step 2
Table 2-2 ip360 Parameters (continued)
Parameter Description
Polling Interval Specify the frequency that you wish the VIS to retrieve reports
from the nCircle device. The default value is 900 seconds.
Note: If the scanner is configured to use a password, the SSH scanner server to
which STRM connects must support password authentication. If it does not, SSH
authentication for the scanner may fail. Make sure the following line appears
exactly as shown in your sshd_config file, which is typically found in the /etc/ssh
directory on the SSH server:
server does not use OpenSSH, the configuration may be slightly different.
To configure the CIDR ranges you wish this scanner to consider:
In the text field, enter the CIDR range you wish this scanner to consider or click
a
Browse to select the CIDR range from the network list.
Click Add.
b
Click Save.
From the STRM Administration Console menu, select Configurations > Deploy
Configuration Changes.
To edit a scanner:
In the Administration Console, click the SIM Configuration tab.
The SIM Configuration panel appears.
Click the VA Scanners icon.
The VA Scanners window appears.
Select the scanner you wish to edit.
Click Edit.
The Edit Scanner window appears.
Update parameters, as necessary. See
Click Save. From the STRM Administration Console menu, select Configurations
> Deploy Configuration Changes.
To delete a scanner:
In the Administration Console, click the SIM Configuration tab.
The SIM Configuration panel appears.
Click the VA Scanners icon.
The VA Scanners window appears.
Managing Vulnerability Assessment
PasswordAuthentication yes.
Table 2-2.
Editing an ip360 Scanner
If your scanner
11