Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - MANAGING VULNERABILITY ASSESSMENT V1 Manual page 12

10 M 360 S
ANAGING IP
Step 5
CANNERS
Enter values for the parameters:
Table 2-2 ip360 Parameters
Parameter
Path
SSH Server Host
Name
SSH Username
Password
Private Key
Authorization
Private Key Path
File Pattern
Managing Vulnerability Assessment
Description
Specify the location on the remote server where the scan results
are stored. The default is /var/ncircle/.
Specify the IP address or host name to the remote server.
Specify the SSH remote server username.
Specify the password to the remote server.
Enable (Yes) or disable (No) private key authorization for the
server. The default value is No.
Specify the private key path. The default is
/opt/qradar/conf/vis.ssh.key. This parameter is not used if the
Private Key Authorization parameter is set to false.
The Vulnerability Assessment Integration Server (VIS) retrieves
reports, at the configured polling interval, from the nCircle device.
Specify the file pattern you wish to retrieve. The filename pattern
used should select only the ip360 exported XML files. It is
important to ensure that only ip360 XML files are included in the
listing. Typical values for this parameter are:
XML2_ip360.d_([0-9]*).a_([0-9]*).xml
We recommend that you use the above pattern, however, you
can also use the below pattern:
XML2_ip360.d_1.a_([0-9]*).xml