Enabling Gtp Decapsulation - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01 Manual
Configuring intrusion detection and prevention devices guide
Hide thumbs
Also See for NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01:
- Manual (444 pages) ,
- Administration manual (1026 pages) ,
- Installation manual (244 pages)
Table of Contents
Advertisement
Enabling GTP Decapsulation
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Chapter 9: Configuring Additional Intrusion Detection and Prevention Features
To enable GTP decapsulation:
In the NSM Device Manager, double-click the IDP device to display the device
1.
configuration editor.
Click Sensor Settings.
2.
Click the Run-Time Parameters tab.
3.
Expand the Run-Time Parameters group.
4.
Select Enable GTP decapsulation support.
5.
Click OK.
6.
Configuring Additional Intrusion Detection and Prevention Features Overview on page 113
NSM and Intrusion Detection and Prevention Device Management Overview on page 5
115
Advertisement
Table of Contents
Troubleshooting
