Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01 Manual page 138

Configuring Intrusion Detection and Prevention Devices Guide
Table 53: Devices Update Job Options
Tab
General
Netconf
ScreenOS and IDP
Table 54: Device Update Job Options
Option
Update When Device Connects
Restart IDP Profiler After Device Update
Update IDP Rulebase Only
Don't Show This Dialog
122
Description
Run Summarize Delta Config–—Summarizes and runs the delta change in the configuration.
Lock configuration during update—Locks configuration while updating device configuration.
Update to candidate config first before commit to running config—Updates the configuration
before committing.
Use confirmed commit—Enables commit confirmed.
Rollback candidate config to running config in error—Rollbacks when there is error generated
during the configuration.
Discard uncommitted changes when exclusive lock is available—Discards any uncommitted
changes during exclusive lock.
Show unconnected devices—Lists all devices that are not connected.
Update when device connects—Updates configuration when the devices are connected.
Firewall Device Options—Not applicable.
Standalone IDP device options—Includes the following option:
Restart IDP Profiler after Device Update—Restarts the Profiler.
ISG Device Options—Not applicable.
To push an update to a specific, single device:
In Device Manager, right-click the device that you want to push the update to and
1.
select Update Device to display the Update Device Options dialog box.
Set update job options using Table 54 on page 122.
2.
Click OK.
3.
Description
Updates the device whenever there exist a connection between the devices.
Restarts the profiler when the device gets updated.
Updates IDP rulebase only.
Does not allow this dialog box to appear again.
For more information, see the IDP Concepts & Examples Guide.
Copyright © 2010, Juniper Networks, Inc.