Using The System; Arming The System; While The System Is Armed - Directed Electronics Python 1601 Owner's Manual

Directed electronics security and remote start owner's guide

Hide thumbs Also See for Python 1601:

Table of Contents

Using the system

To arm the system, press the

button on the remote control.

The siren in the vehicle will "chirp" once and the parking lights will flash

once. If the power door locks have been connected, the doors will

lock. The system will automatically check for errors when it arms.

A U X

If errors are found when arming:

If an alarm trigger zone – such as a door, the trunk, the hood, or a

sensor, was active at the time of arming, the system will "bypass", or

ignore, this trigger zone. This allows the system to continue to protect

your vehicle using the remaining trigger zones.

You are notified of this active zone immediately after arming the system.

The siren in the vehicle will "chirp" again and the parking lights will

flash again. The Status LED indicator in the vehicle will blink in a pattern

to indicate the active zone number error which was found (See Table

of Zones on page 34).

Arming without the chirp (Silent Arm):

AUX

Press the

button at the bottom of the remote once, and then press

the

button. The system will arm without the confirmation chirp. The

parking lights will flash once.

A U X

•

Fail-Safe Starter Kill

The starter is disabled by the system's Fail-Safe starter kill (if installed).

Table of Contents

Show Quick Links

Table of Contents