Power Saver Mode - Directed Electronics Python 1601 Owner's Manual

Power saver mode

Your system will automatically enter Power Saver Mode while armed or
in Valet Mode, after a period of time in which no operation has been
performed. This lowers the current draw on the vehicle's battery. Power
Saver Mode takes over under the following conditions:
Power Saver when the system is armed:
After the system has been
armed for 24 hours the LED will flash at half its normal rate, decreasing
the system's current draw.
Power Saver in Valet Mode:
When the system enters Valet Mode the
Status LED on the Responder LE control center illuminates steadily. If the
vehicle is not used (ignition is not turned on) for a one hour period while
the system is in Valet Mode, the status LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next time the
ignition is turned on and then back off.
38
© 2008 Directed Electronics. All rights reserved.