Timer Mode - Directed Electronics Python 1601 Owner's Manual

➤ Timer mode

To activate the runtime of the vehicles engine during remote start:
Important:
Use Timer Mode in open areas only. Never start and run
the vehicle in an enclosed space such as a garage or carport.
To activate timer mode with an automatic transmission:
1. Remote start the vehicle by pressing
2. The parking lights flash rapidly four times.
3. After 1 second the car starts and the Timer Mode runs for the
specified time period.
To activate timer mode with a manual transmission:
1. Enter the MTS mode.
2. Exit the vehicle and arm the alarm.
3. Enter the timer mode. The parking lights quickly flash 4 times to
confirm entry into timer mode (vehicle does not remote start at this
point). Vehicle begins the timer mode sequence.
To exit timer mode with transmitter:
AUX
• Press twice and then press
times confirming time mode is exited.
To exit timer mode without transmitter:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. Timer Mode is exited and the parking lights
flash slowly four times.
Timer Mode is exited automatically after the sixth run cycle. The park-
ing lights slowly flash 4 times when exiting timer mode.
The same procedure may be used to enter or exit Timer Mode using
the remote transmitter.
© 2008 Directed Electronics. All rights reserved.
AUX
twice and then press
. Parking lights flash slowly four
AUX
AUX
27