HP GbE2c - Blc Layer 2/3 Fiber SFP Option Application Manual page 90

2. Assign an IP interface for each subnet attached to the switch.
Since there are four IP subnets connected to the switch, four IP interfaces are needed
Table 022 Subnet routing example: IP interface assignments
Interface Devices
IF 1 Primary and Secondary Default Routers
IF 2 First Floor Client Workstations
IF 3 Second Floor Client Workstations
IF 4 Common Servers
IP interfaces are configured using the following commands at the CLI:
>> # /cfg/l3/if 1
>> IP Interface 1# addr 205.21.17.3
>> IP Interface 1# ena
>> IP Interface 1# ../if 2
>> IP Interface 2# addr 100.20.10.1
>> IP Interface 2# ena
>> IP Interface 2# ../if 3
>> IP Interface 3# addr 131.15.15.1
>> IP Interface 3# ena
>> IP Interface 3# ../if 4
>> IP Interface 4# addr 206.30.15.1
>> IP Interface 4# ena
3. Set each server and workstation's default gateway to the appropriate switch IP interface (the one in the same
subnet as the server or workstation).
4. Configure the default gateways to the routers' addresses.
Configuring the default gateways allows the switch to send outbound traffic to the routers:
>> IP Interface 5# ../gw 1
>> Default gateway 1# addr 205.21.17.1(Assign IP address)
>> Default gateway 1# ena
>> Default gateway 1# ../gw 2
>> Default gateway 2# addr 205.21.17.2 (Assign address)
>> Default gateway 2# ena
5. Enable, apply, and verify the configuration.
>> Default gateway 2# ../fwrd
>> IP Forwarding# on
>> IP Forwarding# apply
>> IP Forwarding# /cfg/l3/cur
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
6. Save your new configuration changes.
>> IP# save(Save for restore after reboot)
IP Interface Address
205.21.17.3
100.20.10.1
131.15.15.1
206.30.15.1
(Select IP interface 1)
(Assign IP address)
(Enable IP interface 1)
(Select IP interface 2)
(Assign IP address)
(Enable IP interface 2)
(Select IP interface 3)
(Assign IP address)
(Enable IP interface 3)
(Select IP interface 4)
(Assign IP address)
(Enable IP interface 5)
(Select primary default gateway)
(Enable primary default gateway)
(Select secondary default gateway)
(Enable secondary default gateway)
(Select the IP Forwarding Menu)
(Turn IP forwarding on)
(Make your changes active)
(View current IP settings)
Basic IP routing 90