Table of Contents
Advertisement
H2/2 LIGHT GREEN/BLACK (-) auxiliary output
This wire sends a negative pulse every time the remote start is activated. This can be used to pulse the disarm
wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the disarm wire as shown
in the diagrams below. This wire can also be used as a special accessory output. (See Feature Descriptions section
of this guide.)
Relay for Negative (-) Disarm Wire
remote start harness (H3)
H3/1 BLUE status/factory security rearm output
This output is programmable. If programmed for status output, the wire will supply an output at all times the
remote start is operating. If programmed for factory security rearm, the wire will supply a pulse whenever the
remote start times out or is shut down using the transmitter.
H3/2 BLUE/BLACK (-) optional third ignition output
This output provides a 200mA as soon as the remote starter is activated. It can be used to power a relay to ener-
gize a positive (+) third ignition as shown below. This output is capable of driving two relays if necessary.
18
Relay for Positive (+) Disarm Wire
© 1999 Directed Electronics, Inc. Vista, CA
Hide quick links:
Advertisement
Table of Contents
