Table of Contents
Advertisement
3. Press
4. Press
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
➜
remote start
This feature allows you to remotely start and run your vehicle for
a programmable period of time. This makes it possible to warm
up the engine, as well as adjust the interior temperature of the ve-
hicle with the climate control system. If interior heating or
cooling is desired, the climate controls must be preset, and the
fan blower must be set to the desired level prior to remote starting
the vehicle.
i i m m p p o o r r t t a a n n t t ! ! (1) Never remote start your vehicle when the
keys are in the ignition, except when performing Valet
Take-Over, and (2) Never start the vehicle if it is not in
either PARK or NEUTRAL.
To remote start the vehicle:
1. Press
2. The parking lights will flash to confirm that the vehicle will
attempt to start.
3. In gasoline vehicles, the engine will start 4 seconds after the
parking lights flash. In diesel vehicles, the engine will start
when the WAIT-TO-START indicator on the vehicle's dash
goes out or the programmed delay has ended.
18
.
again.
on the transmitter twice within 3 seconds.
© 2005 directed electronics—all rights reser ved
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Automate AM7 and is the answer not in the manual?
Questions and answers
Car starts then immediately shuts off
The Automate AM7 may start and then immediately shut off if it is programmed for voltage sense and the voltage variation between the engine off and running is too small. This can cause the remote start unit to "think" the vehicle has not started and shut it down. Adjusting the voltage check setting to "LOW" may help in such cases.
This answer is automatically generated
battery died remote start wont work How do i reprogram the remote to start the car?
To reprogram the remote for the Automate AM7 after the battery died, follow these steps:
1. Re-sync the remote: If the remote has been pressed many times out of range or the battery was removed, it may fall out of sync. To re-sync, press the remote button several times within range of the vehicle. The alarm will automatically re-sync and respond to the transmitters normally.
2. If reprogramming is needed:
- Open a door (ensure the GREEN wire H1/8 or VIOLET wire H1/6 is connected).
- Turn the ignition to the ON position.
- Within 10 seconds, press and release the Valet/Program switch the number of times corresponding to the desired channel.
- After selecting the channel, press and hold the switch. The LED will flash, and the horn will honk (if connected) to confirm.
- Do not release the Program switch until confirmation is complete.
If the learn routine is locked, it must be unlocked using the Bitwriter® before proceeding.
This answer is automatically generated