Table of Contents
Advertisement
primary harness (H1), 8-pin connector
H1/1 ORANGE (-) ground-when-armed output
This wire supplies a (-) 500 mA ground as long as the system is armed. This output ceases as soon as the system
is disarmed. The orange wire is pre-wired to control the 8618 starter kill relay.
NOTE: If connecting the orange wire to control another module, such as a 529T or 530T window
controller, a 1 amp diode (type 1N4004) will be required. Insert the diode as shown below.
IMPORTANT! Never interrupt any wire other than the starter wire.
H1/2 WHITE light flash output
As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper under
the sliding door is moved to the opposite position (see Internal Programming Jumpers section), this wire sup-
plies a (-)200 mA output. This is available for driving (-) light control wires in Toyota, Lexus, BMW, some
Mitsubishi, some Mazda, and various other models.
© 1999 Directed Electronics, Inc. Vista, CA
13
Hide quick links:
Advertisement
Table of Contents
