Plug-In Led And Valet/Program Switch; Harness 4, (+/-) Door Lock Outputs - Automate 552 Installation Manual

plug-in LED and valet/program switch

These plug into the module. The status LED plugs into the small two-pin socket, while the Valet®/Program switch
should be plugged into the larger blue two-pin connector. The status LED fits in a
Status LED

harness 4, (+/-) door lock outputs

______
H4/A
______
H4/B
______
H4/C
This system can control two common power door lock types without any additional parts! With certain vehicles,
or if an actuator is to be installed, either a 451M Door Lock Relay Satellite or two relays will be required.
IMPORTANT! If you mistake a Type C direct-wired system for a Type A positive-pulse system, the
module will be damaged!
© 1999 Directed Electronics, Inc. Vista, CA
GREEN
EMPTY
BLUE
9 / -inch hole.
32
Valet®/Program Switch
(-) LOCK, (+) UNLOCK OUTPUT
UNLESS USING 451M
(-) UNLOCK, (+) LOCK OUTPUT
23