Adjust/
Maintenance
>Restart
Printer ?
Using the Operation Panel
Adjust/Maintenance (Adjust/Maintenance
selection/setting)
Adjust/Maintenance is used to adjust the print quality and to carry out
printer maintenance.
The options available in Adjust/Maintenance are as follows:
•
Restart Printer
•
Service (for maintenance)
IMPORTANT Service is primarily a menu used by service
representative for maintenance work. There is no need for customers
to use this menu.
1
Press [MENU].
2
Press
or
>
Restart Printer
The procedure described below resets the printer's temporary
conditions, such as the current page orientation, font, etc., set by
commands to their default values. Downloaded fonts and macros are
deleted from the printer's memory.
1
Press
while Adjust/Maintenance > is displayed.
2
Press
or
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. Self test appears while the printer is resetting
itself, followed by Ready.
repeatedly until Adjust/Maintenance > appears.
repeatedly until >Restart Printer appears.
2-65