Kyocera FS-1350DN Advanced Operation Manual page 66

>>RAM Disk Size
>Memory Card
2-48
RAM Disk Size (Setting the RAM disk size)
Use this procedure to set the amount of memory used for the RAM disk.
IMPORTANT The RAM Disk Size menu option only appears when
RAM Disk Mode
1
Press
2
Press [OK]. The message display shows a blinking cursor (_). Press
119MByte
to
512.
This range varies depending on the total memory size of the printer.
The setting exceeding this range is automatically adjusted to the
maximum RAM disk size.
3
When the desired RAM disk size is displayed, press [OK].
4
Press [MENU]. The display returns to Ready. Turn the printer off
and then on again. The selected RAM disk size is activated after the
printer is restarted.
Memory Card (Using the CF card)
The printer is equipped with a slot for a CF card (memory card). By
inserting a CF card into the printer, the following operations become
available.
• Format (Formatting CF card)
For details about the handling of the CF card, refer to CompactFlash
(CF) Card on page 3-6.
IMPORTANT The Memory Card menu options are only displayed
when a CF card is installed in the printer.
1
Press
2
Press
>
is set to On .
while >RAM Disk Mode On > is displayed.
or to display the desired size. Definable RAM disk size is 001
Use and to move the cursor right and left.
while Device Common > is displayed.
or repeatedly until >Memory Card > appears.
Using the Operation Panel