Rear Panel Connections - Directed Audio D2400 Owner's Manual

REAR PANEL CONNECTIONS

1. F F u u s s e e s s - - These fuses protect the
amplifier against internal electrical
damage and are meant to protect
the amplifier only. All other power
connections should be fused at the
source.
The D1200 uses 2-30A fuses, and
the D2400 uses 3-40A fuses.
2. ( ( + + ) ) 1 1 2 2 V V o o l l t t P P o o w w e e r r - Connect this
terminal through a FUSE or CIRCUIT
BREAKER to the positive terminal of
the vehicle battery or the positive
terminal of an isolated audio
system battery.
W W A A R R N N I I N N G G : : Always protect this power wire by installing a fuse
or circuit breaker of the appropriate size within
12 inches of the battery terminal connection.
2. R R e e m m o o t t e e T T u u r r n n O O n n - This terminal turns
on the amplifier when (+) 12 volt is
applied to it. Connect it to the remote
turn on lead of the head unit or signal
source.
2. G G r r o o u u n n d d - - Connect this terminal
directly to the sheet metal chassis
© 2005 Directed Electronics, Inc. all rights reserved
of the vehicle, using the shortest
wire necessary to make this
connection. Always use wire of the
same gauge or larger than the (+)
12 volt power wire. The chassis
connection point should be scraped
free of paint and dirt. Use only
quality crimped and/or soldered
connectors at both ends of this
wire. DO NOT connect this terminal
directly to the vehicle battery
ground terminal or any other
factory ground points.
3. S S p p e e a a k k e e r r T T e e r r m m i i n n a a l l s s - Connect
subwoofers to these terminals.
(Refer to the Speaker Wiring
Diagrams section of this guide.)
9 9