Rear View/ Terminal Board
A AC IN
Connect the included power cord here.
B EXT SPEAKER L and R
Connect speakers (optional) here. Maintain the correct
polarity. Connect the
EXT SPEAKER terminal and the
speaker wire to the
EXT SPEAKER terminal on
both LEFT and RIGHT channels.
Please refer to your speaker's owner's manual.
C VIDEO1, 2, 3 (BNC, RCA, S-Video)
Connect VCR's, DVD's or Video Cameras, etc. here.
D AUDIO1, AUDIO2, AUDIO3
These are audio input terminals.
The input is selectable. Set which video image to allot
them from the audio menu screen.
E DVD1 / HD1
Connect DVD's, High Definition or Laser Discs, etc.
F DVD2/ HD2, RGB2
DVD2/ HD2: You can connect DVDs, High
Definition sources, Laser Discs, etc.
This input can be set for use with an
RGB or component source. (see page
You can connect an analog RGB signal
and the syncronization signal.
(positive) speaker wire to the
G RGB1 (D-Sub)
Connect an analog RGB signal from a computer, etc.
H DVD3/HD3, RGB3 (DVI)
Connect a digital signal (TMDS) from a source with a
This input can be set for use with an RGB3 or DVD3/
HD3 source. (see page E-22)
EXTERNAL CONTROL (D-Sub)
This terminal is used when operating and controlling
the monitor externally (by RS-232C).
• For Y/CB/Cr, connect to the DVD1 or DVD2
• For SCART, this unit provides three ways to connect:
· SCART1: Connect R/G/B to the DVD2 terminals
and composite sync. to the HD terminal.
· SCART2: Connect R/G/B to the DVD2 terminals
and composite sync. to the VIDEO1 terminal.
· SCART3: Connect R/G/B + composite sync. to the