Juniper NETWORK AND SECURITY MANAGER - RELEASE NOTES REV 1 Release Note page 14

Network and Security Manager 2010.4 Release Notes
14
512288—After a device import, duplicate objects are created due to the mismatch in
color between the configuration on the device and on NSM.
512713—After running an import admin directive, NSM changes other configurations
along with admin accounts.
513335—During an IDP firmware upgrade, if an error occurs, the upgrade process
continues indefinitely and cannot be stopped. With the 2010.3 release and later, a
timeout option is provided to stop this process.
513985—During an import for a ScreenOS cluster, the BGP neighbor configuration is
imported to cluster level instead of member level.
514579—PIM-SM settings or any dynamic routing protocol cannot be configured on
an imported firewall because the NSM GUI does not display the Protocol section under
interfaces when SOS devices are added in Cluster mode.
515794—New signature language constructs within-bytes, within-packets, and
context-check created within a customer signature do not appear within the individual
attack object signature set on the device.
515796—NSM UI displays the virtual chassis option for all OS versions of SRX low-end
(100/210/240/650) devices, but does not support SRX devices running versions earlier
than Junos OS Release 10.1.
515797—NSM cannot create a valid custom compound signature attack with new
signature language constructs.
515845—NSM UI does not display the correct hardware inventory output for devices
in an SRX Series virtual cluster.
516416—An APE rulebase configured with a Custom Application fails to update for an
update device operation.
516433—NSM displays an out-of-sync message when the primary device in an SRX
Series virtual cluster goes down and the secondary device takes the primary role. The
workaround is to reconcile inventory.
516478—NSM incorrectly displays tunnel interfaces in a VPN.
516804—An IPv6 configuration imported into NSM immediately shows delta.
517009—A Global MIP object cannot be created on the subinterface of a cluster as
the subinterface (
redundant1
517864—During an SRX Series device update, VPN Manager-configured VPN settings
are being removed from the secondary node of the cluster.
518800—NSM overrides previous rule parameters when a duplicate policy ID is present
in a rule.
518196—If you have an NSM HA set up with MIP IP addresses and perform a delta
config, NSM unsets the secondary NSM server IP address from the cluster members.
519004—You cannot select an interface for an imported SRX Series device from the
VLAN interface in NSM. NSM displays the following error: "Reference to undefined
collection-of-interface-range."
) is not listed in
Object Manager
Copyright © 2010, Juniper Networks, Inc.
.