Juniper JUNOSE SOFTWARE 11.2.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 6-29-2010 Reference Manual page 32

JunosE 11.2.x System Event Logging Reference Guide
log destination syslog
source
log engineering
log fields
log here
8
Use to specify a source interface type and location for events logged to system log at
the specified IP address.
Overrides the actual source interface type and location. The IP address associated
with the specified source interface is used as the source address for subsequent system
log messages.
Example
host1(config)#log destination syslog 10.1.2.3 source atm 0/1
Use the no version to restore the actual source interface type and location.
See log destination syslog source.
Use to enable engineering logs.
Provides troubleshooting information to assist you when contacting Juniper Networks
Technical Assistance Center (JTAC).
Example
host1(config)#log engineering
Use the no form of this command to disable engineering logs.
See log engineering.
Use to select fields to be added to all logs. These fields include a timestamp for the
message, an instance identifier, and the name of the internal software application that
created the message.
Example
host1(config)#log fields timestamp instance no-calling-task
Use the no version to restore the default log field settings.
See log fields.
Use to enable logs destined for a console to be displayed at the current console.
By default, the local console automatically receives all log messages if console is a
destination. The exception is the cliCommand log, whose log events do not appear on
the console.
By default, Telnet consoles do not receive log messages.
Example
host1#log here
Use the no version to disable logs destined for a console from being displayed on this
console.
See log here.
Copyright © 2010, Juniper Networks, Inc.