Mlppp; Mobile Ip; Mpls - Juniper JUNOSE SOFTWARE 11.0.1 - RELEASE NOTES 7-14-2010 Release Note

MLPPP

Mobile IP

MPLS

Failure to meet all of the following conditions for fragmented packets can result
in an incorrect operation during packet classification of the resulting
reassembled packet: [Defect ID 50111]
The initial fragment of a packet must either contain the entire MLPPP
packet or be greater than 128 bytes.
The fragment size of the peer must not be lower than 128 bytes.
The initial fragment of a packet must be larger than subsequent fragments
of that packet.
The clear ip mobile binding nai @realm command does not work. [Defect ID
178652]
Work-around: Use the following version of the command instead:
clear ip mobile binding nai user@realm
The @realm variable and the @ keyword alone do not work for the show ip
mobile binding command. [Defect ID 178653]
Work-around: You can use the user@realm syntax instead to display the
binding for a specific user, as in this example:
host1#show ip mobile binding nai xyz@example.com
Alternatively, you can display the entire Mobile IP binding table by issuing the
show ip mobile binding command without additional options.
The setup rate for Mobile IP client sessions decreases when you repeatedly
bring a large number of sessions down and back up. [Defect ID 178760]
When mobility bindings are present and you delete the Mobile IP home agent
with the no virtual router command, Mobile IP sends a RADIUS Acct-Stop
message with no accounting statistics for the subscribers. [Defect ID 179081]
Work-around: Issue the clear ip mobile binding all command before you
issue the no virtual router command. The clear command clears all the MIP
subscribers and sends a RADIUS Acct-Stop message with the appropriate
accounting statistics for the subscribers.
When MPLS and IS-IS are configured on Ethernet interfaces, you cannot delete
the interface after the IP address is removed. This issue is not a problem on
Ethernet VLAN interfaces. [Defect ID 66813]
Work-around: Issue the no mpls command to disable MPLS, then delete the
interface.
Release 11.0.1
Known Problems and Limitations
45