Juniper JUNOSE SOFTWARE 11.0.1 - RELEASE NOTES 7-14-2010 Release Note page 70

JUNOSe 11.0.1 Release Notes
62
Errata
The following chapters in the JUNOSe System Basics Configuration Guide contain
erroneous references about accessing the software image from the set of
JUNOSe Software CDs:
Chapter 3, Installing JUNOSe Software
Chapter 4, Configuring SNMP
Chapter 5, Managing the System
Beginning with JUNOSe Software Release 11.0.0, we are no longer providing a
set of software CD-ROMs nor can you order software CDs. You can create your
own software discs by downloading the compressed image bundle from the
Download Software page on the Juniper Networks website at
https://www.juniper.net/customers/csc/software.
Alternatively, you can download a compressed version of the software release
by logging on to http://www.juniper.net/customers/support. The .zip file that
you download contains the software release file. The naming conventions
remain the same as the standards followed when the image was delivered on a
set of software CDs, and all references to the software CDs are valid only for the
downloadable bundle.
The Configuring VRRP section in JUNOSe System Basics Configuration Guide,
Chapter 1, Planning Your Network and the Before You Configure IP section in
JUNOSe IP, IPv6, and IGP Configuration Guide, Chapter 1, Configuring IP
erroneously refer to the JUNOSe IP Services Configuration Guide. These
references are corrected to refer to the JUNOSe Service Availability Configuration
Guide.
In JUNOSe IP, IPv6, and IGP Configuration Guide, Chapter 2, Configuring IPv6, the
Before You Configure IPv6 section fails to list all the modules that support IPv6.
You can find complete lists of modules that support IPv6 in the following
appendixes:
E120 and E320 Module Guide, Appendix A, IOA Protocol Support
ERX Module Guide, Appendix A, Module Protocol Support
JUNOSe 10.3.x Service Availability Configuration Guide, Chapter 6, Managing
Interchassis Redundancy fails to clearly describe the working of the master ICR
partition and incorrectly specifies that ICR supports 1:3 subscriber redundancy.
See the JUNOSe 11.0.x Service Availability Configuration Guide for updated
information.
The OSPF MIB section in JUNOSe IP, IPv6, and IGP Configuration Guide, Chapter
5, Configuring OSPF incorrectly mentions that you can obtain more information
about the OSPF MIB from the JUNOSe Software CDs. You can access detailed
notes about all MIBs only from the software image bundle that is available for
downloading from the Juniper Networks website. This changed method of
accessing MIBs is because software CDs, associated with your router model, are
not supplied in Release 11.0.0.