Juniper JUNOSE SOFTWARE 11.0.1 - RELEASE NOTES 7-14-2010 Release Note page 72

JUNOSe 11.0.1 Release Notes
64
Errata
The bgp graceful-restart command section incorrectly mentions that you
can use the default keyword to restore the default condition, which causes
the sending of advertisements of the graceful restart capability to be sent.
However, the correct command behavior is that if you use the default
keyword with the bgp graceful-restart command, advertisements of the
graceful restart capability are not sent.
The neighbor graceful-restart command section fails to state that using
the no version of this command disables advertisement of the graceful
restart capability for specified peers or peer groups only. The no form of
this command does not affect global advertisement of the graceful restart
capability.
The Number of CAM Entries Per Allocation and Free Entries section in Chapter 8,
Policy Resources of the JUNOSe Policy Management Configuration Guide
inadvertently omitted the following paragraph:
The block that is common to the variable-sized entries is not available for
144-bit CAM entries when you configure any 288-bit or 576-bit entries, even
though you remove them later. It is also not available for any 288-bit or 576-bit
entries when the 144-bit entries spill into this block, even though you remove
the 144-bit entries later.
The Note in the timeout command section in JUNOSe Broadband Access
Configuration Guide, Chapter 1, Configuring Remote Access fails to mention that
the router uses the backoff algorithm only for subscriber AAA accounting
messages except Acct-On messages.
In the JUNOSe documentation for Release 9.3.x, 10.x.x, and 11.0.x, the
descriptions about support for DSL line rate information retrieval from access
nodes for transmission to the SRC software, and the sscc
update-policy-request enable command introduced by this feature are
erroneously omitted. This feature was introduced in JUNOSe Release 9.3.0.
The information on this functionality and associated command is missing from
the following guides in the JUNOSe documentation set:
JUNOSe Broadband Access Configuration Guide—Configuring the SRC Client
section in Chapter 1, Configuring Remote Access, and Monitoring SRC Client
Conection Status section in Chapter 2, Monitoring and Troubleshooting
Remote Access
JUNOSe Command Reference Guide N to Z
See Appendix C, Transferring DSL Line Rate Information from an Access Node to
SRC Software, in these Release Notes for detailed information.