Advertisement
WIRING
Wire the venter motor and controls in accordance with the National Electrical Code, manufacturer's recommendations
and/or applicable local codes. UNIT MUST BE GROUNDED. Check ground circuit to make certain that the unit has been
properly grounded. The wiring should be protected by an over current device rated at 15 amperes. CAUTION must be
taken to ensure that the wiring does not come into contact with any heat source. All line voltage and safety control circuits
between the venter and the appliance must be wired in accordance with the National Electrical Code for Class I wiring or
equivalent methods.
Route the venter motor and control wiring with an appropriate wiring method. Refer to Wiring Diagram A.
Refer to SWG Venter Installation Instructions for setting system airflow.
Diagram A
Page 3
Advertisement
