Operation - Dimplex DF2608 Practical User's Manual

Operation

Electric Fireplace Manual Control
The manual controls for the fireplace are behind the access
panel located at the bottom of the fireplace.
A. Three position ON/OFF switch
The switch has two ON positions marked with I and II
The I position is for manual operation.
In this position the built-in remote control is bypassed.
The II position is for operating the unit with the provided
remote control.
When in II position the unit is operated with the ON and
OFF buttons of the remote control.
When the switch is in the center position the unit is off.
B. Flame Action Control
Turn the flame action control knob to adjust the flame
speed to the desired level.
C. Flame Brightness Control
Turn the flame brightness control knob to increase or
decrease the brightness of the flame
and embers.
D. Heater ON/OFF Switch
The heater on/off switch supplies power to the heating unit
when main on/off switch (A) is on.
E. Heater Thermostat Control
To adjust the temperature to your individual requirements,
turn the thermostat control
clockwise all the way to turn on the heater. When the room
reaches the desired temperature, turn the thermostat
knob counter clockwise until you hear a click. Leave in this
position to maintain the room temperature at its setting.
For additional heat, turn clockwise
until you hear the click again and the heater will turn on. To
turn the heater off, rotate the knob fully counter clockwise.
A B C
Resetting the Temperature Cutoff Switch
This unit is equipped with a thermostat which controls the
temperature of the room by turning the heater on and off.
E D
7