Antennas Direct CLEARSTREAM 4 Quick Start Assembly/Installation Instructions

Before attaching the antenna to any surface, TEST RECEPTION
1
r Outdoo Roof M ount O
3
5
7
Fit circular base (2) to reflector
(1), then thread supplied bolt (4)
through the black aluminum bar
passing through the hole in the
base. Repeat this step for the 2nd
loop element (3)
4
5
Call to Learn. Technical A ssistance is availableMonday- Friday,9am- 9pmCentral T ime
1-877-825-5572 andSaturday - Sunday,1Oam- 6pm.
Quick Start Assembly/lnstallation
CLEARSTREAMTM
Connect the antenna
If reception is not as desired, move the antenna and rescan TV/receiver.
Tools Required: # 2 cross point screwdriver.
Before beginning assembly, make sure all pieces needed are present.
2
4
7
Position loop elements (3) so Antennas
Direct logo on each is in same orientation.
Attach combiner bars (7) to each terminal on
the back of each loop element (3) (two
attachments on each loop element). Secure
with supplied wing nuts (5)
2
4
O
Attach the two cross bars (6) (with mounting
hardware) to the rear of the reflector (1) by
removing the back clamp, threading screw
and clamp back on and screwing wing nut
on (5). Note: Screws should be poking
through the back of the reflector
to the TV or receiver and run a full channel
3
5
6
8
Attach
Ohm transformer (7)
3
Instructions
4
in that area.
scan.
The CLEARSTREAMTM 4 comes with:
1) 2 Reflectors
2) LoopElementBases
3) 2 Sets of Loop Elements
4) 2 Bolts
5) 4 Wing Nuts
6) 2 CrossBarswith MountingHardware
Attached and 2 Mast Clamps
7) Combiner Bars with 75 Ohm Transformer
8) Weather Boot
O
coaxial cable to 75 7
Loosen mast clamp wing nuts
enough to slide mast (mast
sold separately) between
mast clamps. After mast is
inserted, tighten wing nuts on
mast clamps.
Assembly Complete.
75 Ohm coaxial "F" connector
should be facing downward.
NOTE: For outside installation,
we have included a weather
boot (8), which can be cut to
cable connector size.
1
Warning! Keep Away
Frorn power Lines.