Cleaner Not Picking Up Solution; Please Do Not Return This Product To The Store - Bissell 9500 User Manual

T
roubleshooting

Cleaner not picking up solution

Possible Causes
1. ReadyTools dial may be at wrong setting.
2. 2-in-1 water tank may not be
seated properly.
3. 2-in-1 water tank may not be
assembled properly.
4. Formula or 2-in-1 water tank is empty.
5. 2-in-1 water tank has picked
up maximum dirty water and red
float door has closed.
6. Red float "door" in the tank may
have closed as a result of bumping
an object or moving machine back and
too quickly.
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

24
w w w . b i s s e l l . c o m
ug120-4042_9500E.indd 24 ug120-4042_9500E.indd 24
Remedies
1. Set ReadyTools dial to either floor
cleaning or tools setting.
2. Pick up both the 2-in-1 water tank and
formula tank and reseat them so they fit
snugly on the unit.
3. Check to make sure the "lip" of the
nozzle is securely hooked into the
groove on bottom of Tank (see page 10).
4. Check fluid levels in heavy duty bladder
and bladder and formula tank.
5. Empty 2-in-1 water tank. Refill heavy
duty bladder with clean hand hot tap
water and replace.
6. Turn the power switch OFF ( O ), allowing
red float door to release into the open the
position. Turn unit back ON ( I ) to continue
cleaning. Be sure your forward and
backward strokes are done at a
slower pace.
authorized service representative.
5/7/08 3:37:49 PM 5/7/08 3:37:49 PM