Press and hold the
3
seconds so the sender/receiver and wireless speaker enter joining mode.
• The power indicators light steadily if the joining was successful.
• The power indicators blink slowly if the joining was not successful.
Note: Rocketboost devices have their own memory. After the devices are joined once,
they will remember each other and join automatically when your devices are
powered on again. Because of this, you can join all of your network components in
the same room before installing them in their permanent locations throughout the
house.
Joining the sender/receiver and wireless speaker to an
existing Rocketboost network
Use this procedure only if you are adding this product to an existing
Rocketboost network.
You need to join both the sender/receiver and the wireless speaker to
your existing hub device, using the following steps.
button on the wireless speaker for more than three
Power on
POWER /JOIN
indicator
BASS
CHARGE
CHANNEL
L - MONO - R
SOURCE
TM
RF-RBWS02
23