Establishing Communication - RocketFish RF-RBWS02 User Manual

To turn the wireless speaker on and off:
When initially connecting to an AC outlet, the device automatically turns
1
on. To turn off the device, press
standby indicator turns red.
If the wireless speaker is off, press
2
lights.

Establishing communication

Rocketboost products form an audio network and each Rocketboost
receiver can select the audio from any Rocketboost sender in the
network.
Important
Every Rocketboost network must contain one hub device, which
helps devices join the network. The network can have only one hub,
which you can enable using the hub switch on the back of all
Rocketboost senders and sender/receivers.
If this is your first Rocketboost product, you should make the
sender/receiver the hub, if you already have Rocketboost products,
you should disable hub mode on this device.
Important: Hub devices must always have power for your network to operate. The hub
device can be in standby (power saving) mode, but must stay plugged in.
Is this your first Rocketboost product?
YES - If this is your first Rocketboost enabled product, you can skip
this section because your sender/receiver and speaker were
previously joined or connected at the factory. To learn how to use
your speakers, see "Listening to music" on page 25.
Note: If you do need to rejoin the sender/receiver and the wireless speaker, see "Joining
the sender/receiver to the wireless speaker" below.
NO - If this is not your first Rocketboost enabled product, proceed to
"Joining the sender/receiver and wireless speaker to an existing
Rocketboost network" on page 23.
. The power indicator turns off and the
to turn it on. The power indicator
RF-RBWS02 21