Xg2000C Components - Fujitsu XG2000C - Switch Hardware Manual

1-2

XG2000C Components

This section explains the names and functions of the various XG2000C components, including the
various indicator LEDs.
XG2000C front
The following explains the names and functions of the components at the front of the
XG2000C.
XFP/Port 1 - 4
upper stand : odd number
lower stand : even number
Link/Act LED
Link/Act LED
• Ports 1-4
• Ports5-20
• Link/Act LEDs (Green)
• Dump Switch
• Mng-LAN
- Mng - LAN Speed LED (Orange) Lights if the link is 100BASE-TX.
- Mng - LAN Link LED (Green)
• Serial Port
• Status LED (Green)
• Alarm LED (Orange)
• Power LED (Green)
16
Installation
Link/Act LED
Link/Act LED
CX4/Port 5 - 20
upper stand : odd number
lower stand : even number
These ports complies XFP MSA. Connection method varies
depending on which XFP modules are installed.
These ports complies 10GBASE-CX4 and are available for
feeding Rated 3.3V/500mA.
Displays the condition of respective port.
Each LED lights when a link is established on its port.
The link is established about few seconds after the received
signal is detected.
Blinks during the XG2000C sends and receives the Frame.
Used to collect maintenance information.
Used when performing maintenance or adjusting the settings
(LAN connection).
Lights when the link is established.
Blinks during the XG2000C sends and receives the
Frame.
Used when performing maintenance or adjusting the settings
(Console connection).
Lights when the XG2000C is in an operable state.
Lights when there is a problem with the XG2000C.
Lights when the XG2000C is receiving power.
Mng-LAN Speed LED
Mng-LAN Link LED
Serial Port
Dump Switch
Mng-LAN
Status LED (Status)
Alarm LED (Alarm)
Power LED (Power)