Turning The Xg2000C Off - Fujitsu XG2000C - Switch Hardware Manual

2-5-2 Turning the XG2000C off

WARNING
1.
Execute the "system shutdown" command.
If the firmware has not been updated yet, then execute "system shutdown" from the com-
mand line.
For details of the system shutdown dommand, refer to the "Command Reference" section in
Refer Refer
the "XG2000C User's Guide".
2.
Disconnect the power cord to the power outlet.
36
Installation and Operation
• When you remove a power plug from its outlet, be sure to pull the only power plug
itself. Pulling on the power cord itself may expose the cores or break the cord, and
cause electric shock or fire.
• Should the XG2000C start giving off heat, smoke, and/or a strange smell, immedi-
ately disconnect the power plug from the power outlet. To make this easy, the
XG2000C should be located close to the power outlet (wall socket or power strip),
and the power outlet must be readily accessible. After the power is disconnected,
contact the vendor's service department immediately. Continued use of the
XG2000C may cause an electric shock and fire. Note that in this case, the state of
data in transmission is not guaranteed.