Table of Contents
Advertisement
1-2
XG700 Components
This section explains the names and functions of the various XG700 components, including the
various indicator LEDs.
XG700 front
The following explains the names and functions of the components at the front of the XG700.
Mng-LAN Speed LED
Serial Port
Mng-LAN Link LED
Mng-LAN
1
Port 1
Mng-LAN
Link/Act LED
• Power LED (Green)
• Alarm LED (Orange)
• Status LED (Green)
• Serial Port
• Mng-LAN
• Ports 1-12
• Link/Act LEDs (Green)
• Dump Switch
14
Installation
Dump Switch
(Dump)
Alarm LED
(Alarm)
Power LED
(Power)
Console
RS-232
2
3
4
5
6
Port 3
Port 5
Port 2
Port 4
Port 6
Link/Act LED
Link/Act LED
Lights when the XG700 is receiving power.
Lights when there is a problem with the XG700.
Lights when the XG700 is in an operable state.
Used when performing maintenance or adjusting the settings
(Console connection).
Used when performing maintenance or adjusting the settings
(LAN connection).
- Mng - LAN Speed LED (Orange) Lights if the link is 100BASE-TX.
- Mng - LAN Link LED (Green)
Xenpak modules which connect to the IEEE802.3 ak compliant
10 Gigabit network served by the XG700.
Displays the condition of respective port.
Each LED lights when a link is established on its port.
The link is established about fifteen seconds after the received
signal is detected.
Used to collect maintenance information.
Status LED
(Status)
Port 11
Port 10
7
8
9
10
11
Port 7
Port 9
Port 8
Link/Act LED
Link/Act LED
Lights when the link is established.
Port 12
12
Advertisement
Table of Contents
